3D Metal Backlit Sign Installation Instructions

3D Metal Backlit Sign Installation (Logo only)

Step 1: Drill holes and thread the wires

• Stick the 1:1 template to the wall where the installation will take place.
• Drill holes at the corresponding positions on the 1:1 template.
• Insert the studs into the acrylic backing of the backlit letters and apply glue on the acrylic backing.
• Finally, install the backlit sign into the corresponding holes on the wall.

• Thread the wires of each backlit letter through the wire holes.

Step 2: Connect the power supply

Method 1: Connect all the wires of the backlit letters in parallel (as shown in the wiring diagram). Then, hide the wires in a wire raceway or wrap them with electrical tape. Connect the wires to the power supply, and finally plug it into the outlet or hardwire the connection.

Method 2: If you want the wall to be smoother, you can install an access panel for the power supply during the wall construction. All the 12V wires will be routed inside the wall and reach this in-wall box.

3D Metal Backlit Sign Installation (With Backing Board)

The backing board design conceals the wires behind the board, with only 1 to 4 wires exposed.

Method 1: You can choose to connect the wires to the power supply behind the wall by drilling a hole, then plug it into the outlet or hardwire the connection.

Method 2: If you don't want to thread wires through the wall, you can wrap the wires with electrical tape or wire raceway, connect them to the power supply on the front of the wall, and finally plug it into an outlet or hardwire it.

NOTE: Installing a 3D metal backlit sign requires knowledge of wire connections. It is recommended to have a electrician handle the installation.

👉🏼 3D Metal Backlit Sign Wiring Diagram